Model 951 - "Starboard Tube Down" Motor Tipper
Never again do you have to disconnect everything and heave your motor up on deck when you want to get underway. In just 30 seconds the St. Croix Motor Tipper lets you reposition your outboard so the powerhead stays above the propeller (saltwater-free) when the dingy is tipped upright.
Its pivoting motor plate is pre-drilled to index with bolt patterns on the most popular 2- and 4-cycle Evinrude, Johnson, Mercury, Honda, Yamaha, and Nissan outboards. Engineered to handle up to 120 lbs., the Motor Tipper can be mounted on transoms up to 1-3/8" thick that are flat on the outside. In many cases, this means you'll need to remove the transom's existing motor wear and clamping plates. If there is a flange on top of the transom, it must go too. But once installed, this highly polished stainless steel timesaver will give you a lifetime of trouble-free service.
Motor Tipper Specifications:
- Height - 11" (27.9 cm)
- Width - 15 1/2" (39.4 cm)
- Depth - 3" (7.6 cm)
- Weight - 24 lbs. (10.9 kg)
- Transom - Not Over 1 3/8" (3.49 cm) Thick
- Capacity - 120 lbs. (54.4 kg)
- Patent Pending
Holes in the tilt plate
that allow you to tilt
the motor in 5 degree
increments, from 30
to 45 degrees.
Requires port tube
of inflatable
to be down.
Holes in the tilt plate
that allow you to tilt
the motor in 5 degree
increments, from 30
to 45 degrees.
Requires starboard
tube of inflatable
to be down.
You'll Find Detailed Specifications & Technical Drawings for Our Products in Our Catalog (download PDF file)
• Removable Davits • Rotating Davits • Lifting Accessories • Custom Applications • TipUp Davits • Outboard Motor Tipper •
• Roll-On Systems • Cranes • Euro Helm & Seating • Folding Ladder • Outboard Motor Bracket •
• About Us • Contact • Catalog • Home •